Setting up the RWZ52
To set the operation mode
The mode selection switch designates in which mode the RWZ52
operates.
Select 0 to operate the RWZ52 as a Digital recognized device. This is the
default mode.
Select 1 to operate the RWZ52 as a Hewlett Packard (Model 1300T)
recognized device.
Digital recommends operating the RWZ52 as a Digital recognized device.
Hewlett Packard mode is available for use with systems and applications
that do not recognize the RWZ52.
To change the operation mode, push in on the button directly above or
below the operation mode window with a small screwdriver or the point
of a pen. (A small screwdriver was shipped with the RWZ52.) The button
above the window decreases the number by one; the button below the
window increases the number by one.
NOTE:
If you change the operation mode, you must
power cycle the drive so that the drive recognizes
the new mode. You may also need to reboot the
host system.
2-4
