Setting up the RWZ52
To set the SCSI ID
Follow these steps to set the SCSI ID.
CAUTION:
Before disconnecting power to any device on the
SCSI bus, verify that the bus is inactive.
Switching off power while the SCSI bus is active
can result in data loss or indeterminate bus
states.
Step 1:Make sure the power to the drive is switched off.
Step 2:Locate the SCSI ID switch on the rear panel of the disk drive.
Refer to Rear panel features.
Step 3:Set the SCSI ID by pushing in on the button directly above or
below the address window with a small screwdriver or the point
of a pen. (A small screwdriver was shipped with the RWZ52.) The
button above the window decreases the number by one; the
button below the window increases the number by one.
NOTE:
If you change the SCSI ID, you must power cycle
the drive so that the drive recognizes the new ID.
You may also need to reboot the host system.
2-3
