DEChub ONE
5
Installing the Module
To install a network module into a DEChub ONE, perform the following steps. Do
not connect the power cord until the module is secured to the DEChub ONE,
mounted (tabletop or rack-mounted), and ready for self-test. Refer to the
Mounting the Single-Slot Hub section and the Connecting the Cables section of
this manual for additional information.
Attach the module to the DEChub ONE
1) Place the mounting tab located on the bottom of the module into the mounting
slot on the bottom of the DEChub ONE, as shown in the figure.
2) Lift the locking L-bracket screw on the DEChub ONE.
3) Pivot the module into place to engage both the 160- and the 48-pin
connectors.
4) Hold the network module and DEChub ONE together and tighten the locking
L-bracket screw. This secures the network module to the DEChub ONE and
activates the network module’s hot-swap switch.
PK–07464–IL
Mounting tab
Locking L-bracket
Network Module
DEChub ONE
