Verification
3-3
Press the control panel Halt button to reset the system.
Press the Power button to power up the system. After powering up the system,
testing begins and status messages display. Check the test results and system
configuration. At the SRM console prompt, restore the EV settings and use the set
command to set the system model number and serial number.
Ê
Insert the diskette into the system drawer diskette drive. Enter the command
show device floppy to initialize the console diskette driver.
Ë
Copy the contents of the diskette to memory.
Ì
Restore the ESC NVRAM contents to memory.
Í
Restore the TOY NVRAM contents to memory.
Î
Enter a show * command to check environment variable settings.
Ï
Issue the command set sys_serial_num to restore the system serial number.
Update the model number by entering the set sys_model_num command.
Ð
You may enter the test command to verify the system.
