Installing the Upgrade
2-5
5. Set the drawer on a cleared, flat surface.
6. Remove the system bus cage cover by removing the two Phillips head screws.
7. Remove the I/O card cage cover by removing the three Phillips screws that
attach the cover to the drawer. Slide the cover off the drawer.
Removing the Pedestal Tray
1. Remove the tray cover by loosening the screws at the back of the tray.
2. Disconnect the cables from the control panel and any optional SCSI device from
the bulkhead connector in the rear right corner of the tray.
3. Unscrew the Phillips head screw holding the bulkhead to the tray.
4. Unscrew the two Phillips head retaining screws and slide the tray off the drawer.
Reverse the above procedure when installing the pedestal tray on the new system
drawer.
Figure 2–3 Removing the Pedestal Tray
PK0685-96
Pedestal Tray
Pedestal Tray Cover