DVM-500Ultra Installation Guide REV B
Page 9
STEP 3:
Install the Waterproof Controller or Monitor.
The waterproof controller can be mounted in a number of
locations, such as on the handlebars of a motorcycle. The
mount enclosed is for mounting on the handlebars. Attach the
mount to the controller. Examples are illustrated below.
Route the console cable to the Main Module (DVM) as well as to the cable attached to the waterproof
controller as shown below to the left. This cable will also include the red and black wires to connect to
a constant 12Vdc power source. As it is not necessary to connect this cable directly to the battery
compartment, we recommend using a more accessible power source. A good location for the Y
section of cabling is under the seat out of harm’s way.
Next, route the DB9 connector to the interface
box location. For Harley Davidson, the camera and monitor cabling can be run over the fuel tank,
underneath the tank bezel. Make sure you allow enough cable clearance for left & right turns. Secure
all cabling neatly with tie wraps to minimize vibration.
Optional Controller
Handlebar Mount
DB9 connector Interface Box
RED
=Co12Vdc
BLACK
=Ground
