DVM-500Ultra Installation Guide REV B
Page 8
SYSTEM INSTALLATION
STEP 1:
Remove Factory Body Trim
Determine a suitable mounting location for the DVM-500 Ultra.
For vehicles such as motorcycles, we recommend installing the Main
Module and I/O box in the saddlebag or radio/trunk box as these
modules are not waterproof. We offer several different mounts and
ideas for mounting on different types of motorcycles and vehicles.
The lid of the saddlebag is an ideal location to allow easy access.
Next, remove the seat so to gain access to the vehicle battery.
STEP 2:
Mount the Front Camera
The bullet camera can be installed on a motorcycle crash
bar, in the faring, or other locations, as desired. Care
should be taken to aim the camera to facilitate record the
best picture, i.e. if mounted on the crash bar; you may
need to aim the camera “up”. Also, if attached to a
motorcycle, parking the vehicle may change the view.
Make sure to test the camera aim to find the best position
that suits your application.
Connect the two green connectors from the camera harness and route the remaining cable towards
your designated DVM location.
For Harley Davidson, the camera and monitor cabling can be run over
the fuel tank, underneath the tank bezel.
Make sure you allow enough clearance for left & right turns.
Secure all cabling neatly with tie wraps
.
To DVM
To Camera
Mount inside the trunk or saddlebag
