Digital-Ally DTM-600, User Manual

Page: 45 / 98

860-00324-00 Rev B 45
⚫
Sync with System Configuration: The time is synchronized with the initially configured
time of the system.
⚫
Sync with NTP Server: The time is synchronized with the time of the NTP server.
⚫
Sync with Management Server(Non-ONVIF): The time is synchronized with the time of
the management server.
⚫
Sync with Management Server(ONVIF): The time is synchronized with the time of the
management server.
⚫
Sync with Latest Server Time: The time is synchronized with the latest time of all servers
in the network.
Time Zone
Select the correct time zone.
System Time
This parameter is available only when Sync Mode is set to
Sync with System
Configuration
or
Sync with Latest Server Time
.
Configure the correct time.
Sync with Computer Time
This parameter is available only when Sync Mode is set to
Sync with System
Configuration
or
Sync with Latest Server Time
.
The system time for synchronization is the time of the local PC.
NTP Server Address
This parameter is displayed only when Sync Mode is set to
Sync with NTP Server
.
Enter the IP address of the NTP server.
Update Interval(s)
This parameter is displayed only when Sync Mode is set to
Sync with NTP Server
.
It indicates the interval for synchronizing time with the NTP server.
The value ranges from 30s to 3600s.
(2)
Choose Setup > Common > Time and click the DST tab to go to the DST tab page.
Figure7-18 DST Configuration Interface
Table7-8
Parameter Description and Configuration
Parameter Description and Configuration
DST
The options are as follows:
⚫
On
⚫
Off
The following parameters are configurable only when DST is set to On .
Start Time
Set the parameter based on actual conditions.
End Time
Set the parameter based on actual conditions.
DST Bias
The options are as follows:
⚫
30mins
⚫
60mins
⚫
90mins
⚫
120mins
Set the parameter based on actual conditions.