Page 24
DGIMST10 -
DigiSender® iMedia® SmartSender™
In the list you will see the
SSID
of iMedia®
SmartSender™. By default this is
iMedia_
SmartSender
. Left click it and choose ‘
Connect
’.
3.
After a few seconds your connection status will
change to ‘Connected’.
4.
Note
: You may be required to enter a
WEP/WPA/WPA2 Key
depending on the current iMedia® Utility Program
Settings, but by default, this is left blank.
Important Note:
If you cannot see the iMedia® SmartSender™ in the list of available Wi-Fi devices then it may
be that it is set to ‘
Station Mode
’ in the iMedia® Utility Program
Configuration Settings
. Connect the iMedia®
SmartSender™ to your router with the included Ethernet Cable. Go to the ‘
AP Mode Network Configuration
Settings
’ Tab (see Section ‘
2.4.3 Network Configuration Settings
’ on page 15 for more information) and
check the box next to ‘
Enable Access Point Mode
’.
3.1.3 Access Point Mode Connection