G-P6019-TM001
ST Electronics (Info-Security)
ISSUE A
5
3.
Installation
To use DiskCrypt Mobile DCM300, simply remove the bottom cover and install your 2.5”
SATA hard drive by connecting it to the 22pin SATA connector within. Detailed step-by-
step instructions are provided in this section.
DCM300 is not shipped with any hard drive. You may purchase a standard 2.5” SATA hard
drive or use your existing 2.5” SATA hard drive with DCM300.
3.1
Installing a hard drive
DiskCrypt Mobile DCM300 supports standard 2.5” SATA hard drives. To install your 2.5”
hard drive, follow these three easy steps:
1.
Turn the DCM300 enclosure over and carefully
remove its bottom cover, by pressing the latch
that can be found on the sides of the unit.
2.
Connect the 2.5” SATA hard drive firmly to the
22pin SATA connector on the tray.
3.
Carefully snap the bottom cover to the top cover.
Note:
•
Please ensure the bottom cover is firmly snapped on to the top cover.
