Digiplex DGP2-641, System Manager'S Manual, Page: 7 / 32

LCD Keypad 5
3.3 STAY ARMING
3.4 INSTANT ARMING
3.5 FORCE ARMING
3.6 BYPASS PROGRAMMING
In order to bypass a zone, the following conditions must be met:
- The zone must have the Bypass option programmed by your installer.
- The Bypass option must be enabled in your User Options.
- Your User Access Code must have access to the zone’s Area Assignment.
- The zone’s area must be disarmed before the zone can be bypassed.
Fire Zones cannot be bypassed.
3.6.1 B
YPASS
R
ECALL
Stay arming will partially arm
your system to permit you to
remain in your home or office
by arming the outer zones
(perimeter) of the protected
area (i.e. doors and
windows). How do I Stay arm?
1) Enter your [
ACCESS CODE
] .
2) Press the [
STAY
] button.
3) If you have access to more than one area, select the area(s) you wish to
Stay arm (refer to section 2.3 on page 4).
This feature is the same as
Stay arming except that there
is no Entry Delay. Therefore,
any armed zone that is
breached will immediately
generate an alarm. How do I Instant arm?
1) Enter your [
ACCESS CODE
] .
2) Press the [5] button.
3) If you have access to more than one area, select the area(s) you wish to
Instant arm (refer to section 2.3 on page 4).
Force arming allows you to
quickly arm your system
when zones are open.
However, once the open zone
is closed, your system will
then arm that zone as well. How do I Force arm?
1) Enter your [
ACCESS CODE
] .
2) Press the [
FORCE
] button.
3) If you have access to more than one area, select the area(s) you wish to
Force arm (refer to section 2.3 on page 4).
You can bypass certain zones
when you arm the protected
area(s). When a zone is
bypassed, it will be ignored
the next time your system is
armed. Once your area is
disarmed, the system will
unbypass the zone. How do I Bypass a zone?
1) Enter your [
ACCESS CODE
] .
2) Press the [
BYP
] button.
3) Enter the zone number (i.e. 01, 02,...96), or use the [ S ] and [ T ] buttons and
press [
BYP
] once the zone you want to bypass appears on the screen. If
“bypassed” does not appear on the screen and the keypad emits a Rejection
Beep, you may not have access to bypass that zone.
4) Repeat step 3 until all zones you want to bypass have been selected.
5) Press the
[
ENTER
] button to save and exit.
Bypass Recall reinstates the
zones that were bypassed the
last time your system was
armed.
How do I activate Bypass Recall?
1) Enter your [
ACCESS CODE
] .
2) Press the [
BYP
] button.
3) Press the [
MEM
] button.
Zones bypassed the last time your system was armed are bypassed.
4) Press the [
ENTER
] button to save and exit.