Digilock NEXTLOCK CUE Series, Manual

Page: 19 / 42

Code Managed
Latch Mechanism
Product Guide
Phone: 707 766 6000
www.digilock.com | sales@digilock.com
121615
PG-NXT-UKC-APS-DEN
Battery Replacement
Support
It is not necessary to uninstall the lock from the door.
Remove the screws and the cover plate. Pull the battery pack from the rear
housing. Replace with four premium
alkaline AA batteries.
Place the battery pack back into the rear
housing and screw cover plate in place.
Sleep Mode
After three consecutive incorrect User Code entries to unlock, the lock will go into “Sleep Mode” for one minute and
for an additional minute for each subsequent incorrect entry. The keypad is disabled while in “Sleep Mode”.
Error Condition Indicator
10 rapid beeps:
The lock is binding which means that either door alignment or items in the locker are preventing the lock from operating.
Press on the door while operating the lock. If error condition persists, contact Digilock support for assistance.
2 sets of three beeps:
The batteries are low. Replace the batteries.
1 beep:
The lock does not recognize the User Code, Manager Code, or Owner Code.
Does not Unlock with the User Code
The lock does not recognize the User Code. For access, operate with the Manager Code. Follow Assign User Code instructions to
assign a new User Code to the lock.
Does not operate with a Manager Code
The lock does not recognize the Manager Code. Follow instructions to Program a New Manager
Code by using the Owner Code. For access, operate with the Owner Code.
Does not operate with the Owner Code
The lock does not recognize the Owner Code. Contact Digilock support.
No Audible Feedback when
=
is Pressed
▪
The lock may be in “Sleep Mode”. The keypad is disabled for one minute while in sleep mode.
▪
The batteries may need to be replaced.
▪
The front unit may not be properly connected to the rear unit. Remove the lock from the door and check the cable connection.
▪
If error condition persists, contact Digilock support.
1 2 3