LX-DANTE
User’s Guide
v1.00
1 INFORMATION FOR THE USER
This device complies with part
15
of FCC rules. Operation is subject to the following two conditions: (
1
) This device may not cause harmful interference, and
(
2
) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part
15
of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions contained in this data sheet, may cause harmful interference to radio and
television communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* reorient or relocate the receiving antenna
* increase the separation between the equipment and the receiver
* connect the equipment into an outlet on a circuit different from that of the receiver
* consult the dealer or an experienced audio television technician.
Note
: Connecting this device to peripheral devices that do not comply with CLASS B requirements or using an unshielded peripheral data cable could
also result in harmful interference to radio or television reception. The user is cautioned that any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to operate this equipment. To ensure that the use of this product does not contribute
to interference, it is necessary to use shielded I/O cables.
Warning:
Electrostatic discharge (ESD) can damage several components on the board. To avoid such damage in handling the board, take the following precautions:
Bring the device and everything that contacts it to ground potential by providing a conductive surface and discharge paths. As a minimum, observe these
precautions:
●
Disconnect all power and signal sources.
●
Place the device on a grounded conductive work surface.
●
Ground yourself via a grounding wrist strap or by holding a grounded object.
●
Ground any tool that will contact the device.
Due to the reduced length of the PCI EXPRESS
TM
bus connector and the resulting lack of mechanical stability, we strongly advise against transporting the
PCIe
®
card(s) installed in a computer, unless its chassis or case provides a dedicated support to keep the card securely in place in order to avoid physical
damage.
2 IMPORTANT NOTICE
This card has been tested and found to comply with the following standards:
●
International: CISPR22 Class B
●
Europe: EMC 89/336/CEE (1992) specifications
●
United States: FCC Rules-Part 15-Class B (digital device)
In order to guarantee compliance with the above standards in an installation, the following must be done:
●
the provided cable must not be modified
●
additional cables used must have their respective shield connected to each extremity
4
