Pro Tools Setup Guide
17
17
17
17
4)
Make Sure MIDI DYNAUTO is enabled on the 328. Set Automation mode to READ/WRITE.
5)
In Pro Tools, arm the new MIDI track to record, and verify MIDI data reception.
6)
Once MIDI data has been verified, you are free to record a pass of automation. Grab a
handful of faders, and do a test-pass while in MIC/LINE Fader bank.
7)
After the test-pass has been recorded, rewind Pro Tools and play the pass back to the 328.
8)
Faders should move accordingly – if they do not, verify your settings and try again. If MIDI
data is registering on the ProTools level meter when faders are being recorded, check the
MIDI Cable returning to the 328.
Once your pass has been recorded, you may want to edit it within Pro Tools. If you have Pro
Tools 5.0 or later, editing takes place as follows. If you have Pro Tools 4.3 or earlier, please
continue to read this section, as the proceedure is similar for your version.
1)
Go to the Edit window in Pro Tools, and locate the MIDI track containing the automation
pass.
2)
Select the way the data is to be displayed – we recommend pure Controller Changes.
<Automation Set>
<Automation Set>
<Automation Set>
<Automation Set>
Mode: READ/WRITE
Mode: READ/WRITE
Mode: READ/WRITE
Mode: READ/WRITE
Editing the Automation Pass
Editing the Automation Pass
Editing the Automation Pass
Editing the Automation Pass
