DigiDesign Bomb Factory, Manual

Page: 42 / 84

Bomb Factory Plug-ins Guide 36
How the Moogerfooger 12-Stage
Phaser is Used
LFO Section
Control the LFO using the Amount and Rate
knobs and the Lo/Hi selector switch.
Amount varies the depth of phaser modulation,
from barely perceptible at the full counterclock-
wise position, to the full sweep range of the
phaser (full clockwise or “Kill” setting).
Rate determines how fast the LFO oscillates. The
LFO light blinks to give a visual indication of the
LFO rate.
The Lo/Hi switch selects the range of the Rate
control. When the switch is Lo, the Rate control
varies from 0.01 Hz (one cycle every hundred
seconds) to 2.5 Hz (2.5 cycles every second).
When the switch is Hi, the Rate control varies
from 2.5 Hz (2.5 cycles every second) to 250 Hz
(two hundred fifty cycles per second). With such
a wide range of rates available, obviously you’ll
need to adjust Rate after you flick the Lo/Hi
switch to get the sound you desire.
Phaser Section
Control the Phaser with the Sweep and Reso-
nance knobs and the 6-Stage/12-Stage switch.
Resonance adjusts the feedback of the analog fil-
ters. As you add more resonance, the peaks
caused by the filters get sharper and more no-
ticeable.
Sweep adjusts the center frequency point of the
filters. Use it in conjunction with Amount to
control the frequencies affected by the phaser.
Audio Input
Finally, the Drive control sets the input gain.
LED Indicators
Three LEDs provide visual feedback. Level glows
green when signal is present. LFO blinks to show
the LFO rate. And Bypass glows either red (by-
passed) or green (not bypassed) to show whether
or not the effect is in the signal path.
Responses of a phaser with high resonance
Sweep adjusts the center frequency point