DiGiCo S21
1-6
1.3.2 Channel Setup View ...............................................................
Channel Name
Column
Title Label
Add To Set
Gain Tracking On/Off
Open Safes View
Select Solo Assignment
Switch to EQ View
Select input source
Filters
Delay
Tubes
EQ
Dyn 1
Dyn 2
Auxes
Direct Out
Groups
Insert A
Insert B
Master Rotary
Assignment
Channel Mono/Stereo switch
Touching the input block at the top of the channel opens the Channel Setup view
Each column represents a section of the channel processing strip and these columns can be selected by touching their title label.
Once a column is selected, the parameters available in that section are assigned to the worksurface Master Rotaries to the right of the
screen.
Some columns are subdivided into blocks eg Input processing consists of Filters, Delays and Tubes.
Touching any of these blocks will assign the Master Rotaries to the settings for that block.
Note that touching the Filter block or the EQ block will both display the EQ view but with different bands selected.
Note: When any expanded view is open on the Master screen, the Master Rotaries no longer have their standard de-
fault assignment and are instead assigned to the parameters in the expanded view which is currently displayed.
The buttons in the top bar provide the following functions:
Switching the channel from
Mono to Stereo mode
Adding the channel to a
Spill Set
(see Spill Set section later in this document)
Switching
Gain Tracking On/Off
for the channel
Opening the
Safes View
which allows channel parameters to be protected from Snapshot Recall
Selecting which
Solo
Busses the channels are assigned to
Touch the
keyboard icon
at the top left of the screen to enter a channel name.
Touch the
Equaliser
button at the bottom left of the screen to switch to the EQ view for the currently selected channel.
To select an
Input Route
touch the block below the
Source
label and the Input routing view will open.
To select an
Output Route
touch the
Direct Output
block in the
Outputs
column and the output routing view will open.
To assign the channel to a
Group buss
touch the
Group Assigns
button in the
Outputs
column
To view and adjust
Aux Send Options
for the channel touch the relevant
Aux Sends button
in the
Outputs
column
