Digicam Premium DPI series, User Manual

Page: 15 / 158

User Manual of Network Video Recorder
15
No. Name Description
18 F2 Button Cycle through tab pages.
In synchronous playback mode, it is used to switch between channels.
Troubleshooting Remote Control:
Make sure you have installed batteries properly in the remote control. And you have to aim the remote
control at the IR receiver in the front panel.
If there is no response after you press any button on the remote, follow the procedure below to troubleshoot.
Steps:
1. Go to Menu > Settings > General > More Settings by operating the front control panel or the mouse.
2. Check and remember NVR ID#. The default ID# is 255. This ID# is valid for all the IR remote controls.
3. Press the DEV button on the remote control.
4. Enter the NVR ID# you set in step 2.
5. Press the ENTER button on the remote.
If the Status indicator on the front panel turns blue, the remote control is operating properly. If the Status indicator
does not turn blue and there is still no response from the remote, please check the following:
•
Batteries are installed correctly and the polarities of the batteries are not reversed.
•
Batteries are fresh and not out of charge.
•
IR receiver is not obstructed.
If the remote still cannot function properly, please change a remote and try again, or contact the device provider.