9
Viewing the MAX, MIN, and AVG Readings
1. Press
MAX/MIN
button to step through the maximum (MAX), minimum
(MIN), and average (AVG) readings. The elapsed time since entering
MAX/ MIN/AVG mode, or the time at which the minimum or maximum
occurred, appears on the display.
2. Press and hold the
MAX/MIN
button for three seconds to exit the
Max/Min/Avg mode and return to normal operation.
Recording/Data Logging Operation (Meter)
1. Press
Power on/off
button to turn the unit on. The
first value immediately shown is the number of data
logging sample points remaining (Fig. 6).
2. Press
Rec
/
button to begin recording; the REC icon
will be appear to indicate the meter is recording data
measurements.
3. To stop recording, press and hold
Rec
/
button for
three seconds until the REC icon is no longer shown.
4.
Note:
A maximum of 10,000 sample points is avail-
able (Fig. 6). As you log temperature readings, this
value will be lower each time you turn on the meter.
When the memory is full (with 0 sample points
remaining), the first value shown will be “FULL”
rather than a number. Or if you try to record, the
REC
icon will flash five times and disappear. At this point, you are
no longer able to record until the memory is cleared. (See "Changing
Setup Options", "Clear Memory Operation" on pages 7–8.)
Recording/Data Logging Operation (Software)
1. First install software on PC following the set up wizard (see “Software
Installation” on next page). Once software is successfully installed, the
data logging software icon shortcut will be automatically placed on your
PC desktop.
2. Connect thermometer to your PC via the supplied USB cable.
3. Power the meter on.
4. Open the installed Data Logger Software by double-clicking on the icon
on your PC desktop.
5. In the Data Logger Setting menu, confirm time and select date format,
sampling rate, memory full directions, auto power-off status, and start
method; then select “OK”.
You must set these parameters before meter
will record measurements.
a.
Note:
Manual start method is controlled by user pressing REC
button on instrument. Automatic start method will activate
recording via the software instantly once selected.
Fig. 6
