11
6 INSTALLATION AND OPERATING INSTRUCTIONS
SLASHER INSTALLATION
1. Place the product on a firm, levelled surface that is large enough to safely accommodate this product, loader and all workers involved
in the mounting process.
2. Be sure all connection points are properly secured.
3. Refer to the operators manual(s) for your loader quick attach and follow the mounting instructions contained there in.
4. Carefully raise the loader arms and cycle the tilt cylinder to check clearance and to verify that all mounting procedures have been
successfully completed.
SLASHER HYDRAULIC CONNECTIONS
1. Attach the quick couplers to your loader as per the instruction in your machine operator’s manual.
2. Carefully raise the loader arm and cycle the tilt cylinders to check hose clearance and check for any interference.
3. To assure optimum motor life, run hydraulic motor for hour on approx. 1/3 RPM before application of full load.
The Digga Slasher receives its power from the parent machine through the auxiliary valve circuit with quick release couplers normally located
on the machine arm near the front. Hook up hoses to auxiliary hydraulics.
Engine must be shut off. Pressure may need to be released.
Ensure your machine flow, pressure and load ratings do not exceed the maximum ratings stated on your slasher serial tag. It is the
responsibility of the operator to ensure the unit’s maximum rated flows, pressure and load ratings are never exceeded.
Exceeding these will void warranty.
IF YOU ARE IN DOUBT CONTACT YOUR NEAREST DIGGA DEALER FOR ASSISTANCE.
NOTE: IT IS IMPORTANT TO MAKE SURE THE LOCKING MECHANISM ON YOUR QUICK ATTACH IS
ENGAGED, THEREFORE LOCKING THE ATTACHMENT ONTO THE MACHINE.
SAFETY FIRST!! READ AND UNDERSTAND THE SAFTEY INTRUCTIONS BEFORE BEGINNING ANY
SLASHER MOUNTING.
DO NOT LOCK AUXILIARY HYDRAULICS OF YOUR MACHINE IN THE “ON” POSITION. FAILURE TO
OBEY THIS WARNING COULD RESULT IN DEATH OR SERIOUS INJURY.