CHANGING THE PLANETARY
To gain access to the planetary the drum must first be removed. Follow the above
procedure for removing the drum.
1. Tag and disconnect the power and return hoses along with the case drain hose
from the hydraulic motor and plug the motor ports to prevent contaminates from
entering the hydraulic system.
2. Remove the .6100mm bolts securing the planetary to the planer and remove the
planetary.
3. Check to be sure the new planetary is
filled with oil. If not, fill with approximately 2
quarts of Castrol SP 320 gear oil.
4. Remove the hydraulic motor from the
planetary. Scrape any silicone from the
hydraulic motor and apply new RV 10
silicone to the motor to seal the connection
between the motor and the planetary.
Bolt the hydraulic motor onto the new
planetary using the existing hardware.
5. Position the new planetary into the
planer housing and reinstall the .6100mm
capscrews, flat washers and lock nuts.
Check to ensure that the hydraulic motor is
in the correct position with the ports turned
up. Torque to specification
6. Reinstall the drum as described in
"CHANGING THE DRUM".
7. Re-connect the hydraulic hoses and fittings to the motor.
CHANGING HYDRAULIC MOTOR
1. Position the planer on its side or in such a fashion that the planetary oil will not
leak out when replacing the motor.
2. Tag and disconnect the power and return hoses along with the case drain hose
from the hydraulic motor.
3. Remove the capscrews securing the motor to the planetary.
4. Scrape the mating surface of the planetary, removing all existing silicone, to
prepare it for the new motor.
5. Apply new RV 10 silicone to the motor to seal the connection between the motor
and the planetary. Bolt the new hydraulic motor onto the planetary using the existing
hardware. (Check to ensure that the hydraulic motor is in the correct position with the
ports turned up.) Torque to specification
6. Re-connect the hydraulic hoses and fittings to the motor.
Profila Operator’s Manual Maintenance and Service
22
