Continuous or excessive overheating may cause machine damage.
SPECIAL APPLICATIONS
LARGE AREA
DIGGA'S independent depth control design allows for continuous milling.
Instead of planing pass 1, 3, 5 and then going back and resetting the planer
for passes 2 and 4, the DIGGA planer allows for individual depth control from
the operator's seat to enhance performance and continually mill large areas.
MILLING AROUND
MANHOLES
For best visibility when milling
around manholes it is
recommended that the planer
be shifted to the right. The
planer is not designed to mill
around tight corners, therefore
it is recommended that four to
six passes be made on each
side of the manhole. NOTE:
The more passes the less
amount of manual clean-up
required.
DEEP CUTS
To achieve a deep cut the width of the drum, make the first cut at the
recommended depth for the material being milled and then reposition the
planer at the beginning of the pass and reset for double the recommended
depth. Example: Make the first cut with the depth controls set at 100mm and
then set the depth control at 100mm for the second pass and so on and so
forth until the desired depth is obtained.
Profila Operator’s Manual Installation Instructions
15
