Digga PD 30 HP-7, Operator'S Manual

Page: 9 / 44

9
KNOW WHERE UTILITIES ARE
Observe overhead electrical and other utility lines. Be sure equipment will clear them. When digging, call DIAL
BEFORE YOU DIG ON 1100 (in Australia), or your local UTILITIES location service provider for location of buried utility
lines, gas, water, and sewer, as well as any other hazard you may encounter.
EXPOSURE TO RESPIRABLE CRYSTALLINE SILICA DUST ALONG WITH OTHER HAZARDOUS DUSTS MAY
CAUSE SERIOUS OR FATAL RESPIRATORY DISEASE.
It is recommended to use dust suppression, dust collection and if necessary personal protective equipment during the
operation of any attachment that may cause high levels of dust.
REMOVE PAINT BEFORE WELDING OR HEATING
Hazardous fumes/dust can be generated when paint is heated by welding, soldering or using a torch. Do all work
outside or in a well ventilated area and dispose of paint and solvent properly. Remove paint before welding or heating.
When sanding or grinding paint, avoid breathing the dust. Wear an approved respirator. If you use solvent or paint
stripper, remove stripper with soap and water before welding. Remove solvent or paint stripper containers and other
flammable material from area. Allow fumes to disperse at least 15 minutes before welding or heating.
END OF LIFE DISPOSAL
At the completion of the useful life of the unit, drain all fluids and dismantle by separating the different materials (rubber,
steel, plastic, etc.). Follow all federal, state and local regulations for recycling and disposal of the fluid and components.
WARNING
WARNING
WARNING
WARNING
5 SAFETY PRECAUTIONS - GENERAL INFORMATION