Digga Magnum II Series, Operator And Parts Manual

Page: 34 / 56

34
3. Remove the right and left skid shoes along with the left side filler plate.
4. Remove the dirt rings by removing the four .25” flat head screws.
5. With the dirt rings free to “float”, begin rotor removal by first gently swinging the left end of the
rotor through the slot in the mulcher mainframe. With the left end of rotor free from the
mainframe, pull right side of rotor out of mainframe, completely freeing the rotor from the
mainframe.
NOTICE: Be careful not to let rotor shaft ends come into contact with the mainframe which
could cause damage to the rotor shaft threads or create dents or burrs in the shaft.
6. Reverse process for installing the rotor back into the mainframe.
7. Follow Steps #15 and #17 through #25 under “REPLACING AND/OR SERVICING THE
LOWER BEARINGS”.
CHECKING AND/OR CHANGING OIL IN OVERHUNG LOAD ADAPTER
Before checking, adding or changing the oil in the overhung load
adapter, mulcher must be sitting in operating position with skid
shoes flat on the ground as shown. See “LUBRICATION
SPECIFICATIONS” for oil type and capacity.
MULCHER POSITION WITH SKID
SHOES FLAT ON GROUND
CHECKING AND/OR ADDING OIL
1. Remove right side maintenance cover from the back of the mulcher. Clean around the
appropriate fill level plug and remove plug. Check to make sure oil level is at fill level plug.
2-BOLT FLANGE 4-BOLT FLANGE
FILL LEVEL PLUG
(36” MULCHERS ONLY)
FILL LEVEL PLUG
(60” MULCHERS)
DRAIN PLUG
(60” MULCHERS)
DRAIN PLUG
(36” MULCHERS ONLY)
DRAIN PLUG
FILL LEVEL PLUG
MAINTENANCE & SERVICE
PM-000102-A OCTOBER 2017 33