MODULATOR SETUP AND CONFIGURATION
DEVICE Programming and Setup
To setup and program the Encoder you can use the GUI interface or the LCD Front Panel
Note - The installer can enable DHCP via front display - under "Network Setup"section if
desired (Default "DISABLE")
Connecting to the GUI Interface:
Factory Default IP: 192.168.1.9
1. Connect an Ethernet cable directly (
no Cross Over cable required
) to the Web Management Port
on the rear panel of the encoder or connect the Ethernet cable to an Ethernet switch. Connect an
Ethernet Cable to your PC/Laptop.
2. Modify your PC/Laptop IP address to 192.168.1.11.
3. Enter ‘192.168.1.9’ into your web browser.
4. The Welcome Page will shown.
Welcome
page will be displayed as shown
7
HD-1605 Manual V1.0
