Modulator Configura#on via Front Panel LCD
Once the encoder is powered up it will go through its initial booting process. Once the unit has completed
its initial “Booting” up process the LCD will display IN-1..., Bit Rate information, CHANNEL-1...., and other
information in the LCD Display Window. When visible the unit is ready for programming or operation.
Main Menu
– To access the Main Menu ,irst enter the password by pressing the OK button. Use the Scroll
Up/Down buttons to enter the password. The password is -
0000
.Once the password is entered press the
OK button again and the LCD Screen will display
“ ….HD Series”.
Common Setup Menu
Output Channel
– Use the Scroll Up/Down button to change the output channel. Use the
Scroll Up/Down buttons to select the desired Output Channel. Once the desired output
channel is selected press the OK button to set the channel.
The LCD Display will show both the channel number and the frequency number of the
output channel (example: 39 (606.5 MHz))
Delayed Audio
– Use the Scroll Up/Down button to change the Delayed Audio. Use the
Scroll Up/Down buttons to select the desired delay from 0~20000ms. Once the desired
delay is selected press the OK button to set.
Device Address
– Use the Scroll Up/Down button to select Device Address. Press the OK
button to enter the Device Address menu. Use the Scroll Up/Down to select the Desired
Address ranging from 1 to 255 then press OK to set. A unique device address is required if
setting up more than 1 encoder per site. This allows the user to distinguish each device.
Default Con0iguration
–To reset the Encoder/Modulator back to the factory default select
the Default Con,iguration Menu. Press OK to enter the Default Con,iguration Menu. There
are three options that you can choose. Using the Up/Down button select No, New Zealand
and Australia. Press OK to reset all programmed settings back to the factory default setting.
Back to Main-
Select Back to Main to escape the Common Setup Menu.
RF Setup Menu
FEC
-
The FEC is default 7/8.
GUARD INTERVAL
– The GUARD INTERVAL is default 1/32.
OFDM -
Use the Scroll Up/Down button to select the OFDM menu. Press the OK button to enter the
OFDM menu. Use the Scroll Up/Down to select the OFDM 2K or 8K. Press OK to set.
TS ID
– Use the Scroll Up/Down button to select TS ID. Press the OK button to enter the TS ID menu.
Use the Scroll Up/Down button to select the desired Stream ID ranging from 1 to 65535 then press
the OK button to set.
Network ID
– Use the Scroll Up/Down button to select Network ID. Press the OK button to enter the
Network ID menu. Use the Scroll Up/Down button to select the desired Network ID ranging from 1
to 65535 then press the OK button to set.
15
HD-1605 Manual V1.0
