•
5
•
FEATURES
1.
Charger plug
2.
Jump start ON/OFF switch
3.
Built-in light and switch
4.
LED indicators
5.
Battery clamps
6.
USB port
7.
Battery status and USB
ON/OFF button
1
2
3
4
6
7
5
CHARGING THE INTERNAL BATTERY OF THE PORTABLE POWER
IMPORTANT!
CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS, TO KEEP THE
PORTABLE POWER’S INTERNAL
BATTERY FULLY CHARGED AND
PROLONG BATTERY LIFE.
CHECKING THE LEVEL OF THE
INTERNAL BATTERY
Press the
Battery Status
button on the
front of the unit. The LED lights will indicate
the current charge level as follows:
(green) solid –
100%-70% of full charge.
(yellow/orange) solid –
70-30% of full charge.
(yellow/orange) flashing –
Less than 30% of full charge.
CHARGING THE INTERNAL BATTERY
Charge the internal battery for the Portable
Power using an extension cord (not included).
NOTE:
Use of an improper extension cord
could result in a risk of fire and electric shock.
1.
To charge, plug an 18 AWG or larger
extension cord into the charger plug on
the side of the Portable Power.
2.
Plug the extension cord into a 120VAC
electrical wall outlet.
3.
While the Portable Power is charging,
the
(yellow/orange) LED will be lit
until the level reaches 70% of charge,
then the (green) LED will be solid
until it is fully charged. When fully
charged, the (green) LED will pulse.
Complete charging may take up to
72 hours.
4.
When the internal battery is fully charged,
the charger will automatically go into
maintain mode and maintain the battery
at full charge without damaging it. When
in maintain mode,
the (green) LED
will pulse,
as long as there is an AC cord
connected to the charging port.
5.
Charge the jump starter as soon as
possible after use.
CHARGING THE INTERNAL BATTERY
WHILE DRIVING
You may also charge the internal battery
while driving, using a male-to-male
charger cable (part number 94500109 –
not included).
IMPORTANT:
DO NOT CHARGE
INTERNAL BATTERY FOR MORE THAN
30 MINUTES OR LEAVE THE BATTERY
UNATTENDED. IT COULD EXPLODE,
CAUSING PROPERTY DAMAGE OR
PERSONAL INJURY.
1.
Make sure the car is running.
2.
Insert one end of the accessory cable into
the 12V DC power outlet.
3.
Insert the other end of the accessory
cable into the vehicle’s accessory outlet
(lighter socket).
NOTE:
The
green and yellow/orange LEDs
do not operate during this method of
charging. Using this method to charge the
battery overrides the maintain mode and the
battery can be overcharged.
4.
Monitor the progress of the charge by
pressing the
Battery Status
button on
the front of the unit. When the battery is
fully charged, disconnect the accessory
cable from the Portable Power, then from
the lighter socket of the vehicle.
NOTE:
Completely disconnect the charger
cable when the engine is not running.
