DIDIESSE DIDI, Instructions For Use And Maintenance Manual

Page: 19 / 23

36 37
Installation
5.1 COFFEE BREWING
POD
In sequence the following operations must be performed:
1. Place the cup / cup under the coffee dispensing spout;
2. Lift the lever upwards and insert the pod in the pod holder (see Fig. 7);
3. Press the lever downwards, to the point where it locks, signalled by a click (see Fig. 8);
4. In any case, check that the indicator light on the button is not flashing;
5. Press the button and wait for the desired quantity to be erogated;
6. At the end of erogation, press button a lift up the lever C, in order to remove me pod (of the desired
quantity of coffee, deactivate the coffee extraction button A and lift the lever C upwards again, so as to
finally be able to remove the pod from the compartment at the extraction chamber).
CAUTION:
When brewing coffee, do not bring the lever C to the rest position.
Once this simple operation has been carried out and after making sure that the Didì coffee machine in your
possession complies with the power supply parameters set by the local electricity distribution network (220
V - 50-60 Hz), insert the power plug into a power outlet, then position the switch in position 1 (Fig. 5) activate
the coffee group. To be able to switch to coffee extraction, wait for the luminous button LED inside the button to
become permanent (Fig. 6).
At this point the coffee machine is ready to make a coffee.
Fig. 5 Fig. 6
4.5 STAND BY
The Didì is equipped with an electronical temperature system, this system allows the an automatic shutdown in
case of inactivity cancelling the electrical consumptions. When the machine is switched on, the rim of the button
on the front will flash slowly, 1 sec. On, 1 sec. Off (see fig. 6).
This flashing indicates the creating of coffee group heating and the active home mode (active stand by).
Once the optimal temperature is reached, this edge will remain on steady. Before this condition, it will not be
possible to make coffee. If the machine remains unused for a period of 30 minutes, the electronic system will
disconnect the voltage from the resistor. This condition is understandable from the instantaneous flashing of the
button, 0.5 sec On, 0.5 sec. Off (the machine is in stand-by). To exit this condition, just hold down the dispensing
button for 2 seconds (Fig. 1). It is possible to disable the stand-by to have the machine always ready to dispense
(professional use), proceeding in this way: with the machine off, keep the dispensing button pressed (Fig.1), at the
same time turn on the machine with the 0 / 1 place in the back of the machine (Fig.5). The edge of the button will
flash slowly, this indicates that the machine is in home mode, therefore with the stand-by active, to change mode,
press the dispensing button once.
You will notice that the button changes flashing mode, passing to a quick flash, to confirm the professional mode
(stand by disabled) switch off the machine again with the 0/1 button (Fig. 5).
Upon restarting, a quick flash will indicate that the operation was successful.
To return to home mode, repeat the ignition operation, and press the dispensing key, keeping in mind the flashing
modes where slow flashing indicates home mode (active stand-by) and fast flashing professional mode (stand
by off).
CAUTION:
Only pods with a 44 mm diameter must be inserted in the pod compartment. The single-dose pods are designed
to dispense a single coffee / product. Do not re-use pods after use. The insertion of 2 or more pods causes the
machine to malfunction.
Fig. 7
C
Fig. 8
C
Fig. 9
A
Maintenance