05 Main Menu (Page 2)
Heater Control (Operation modes)
The mod can be used in up to 5 operation modes. The mode can be selected in this menu.
The default operation is either standard (0, power setting) or temperature controlled
vaping (1). With the “Expert Mode” (Extended Functions Mod-Menu) enabled, additional
operation modes are Heater Protection (2), P
and Bypass (4, mechanical
mod). With Expert Mode disabled, the menu options 2..4 are masked out.
ower Boost (3),
Battery Status
The Check Battery item shows the battery voltage with little current drained (Ub0) and the
battery voltage under load during the last puff (UbL). The difference is the voltage drop of
the battery. A high drop (>0.4V) indicates a poor battery or contact problems.
Please note that every battery has an inner resistance and that therefore the voltage at its
contacts always drops when current is drained. The more current is drained, the higher the
drop will be. Always remember this behaviour.
Commonly used batteries of 18650 size have inner resistances of about 15mOhm up to
80mOhm. Smaller sized batteries even have higher resistances. Generally speaking, the
batteries with high capacity have higher inner resistance (e.g. 2500mAh NCR has 75mOhm)
and those with lower capacity also have lower inner resistance (e.g. 2100mAh Sony Konion
has 15mOhm).
0. Standard Mode
In the standard operation mode the wattage selected in the power setting menu is applied
to the coil, unless the voltage would be greater than 12V or the current greater than 15A,
which depends on the coil resistance.
For example with a coil resistance of 4 Ohms and a power setting of 40W, the required
voltage at the coil is 12.7V. With 4 Ohms the maximum wattage is 36W ((12V)²/4R=36W).
Or, if the coil resistance is 0.1 Ohm the maximum power is 22.5W, because (15A)²*0.1Ohm
=22.5W.
As can be seen from the examples, with high coil resistance the power is limited by
the maximum voltage of 12V and with low resistances by the maximum current of 15A.
The fact is also reflected in the feature list: A power of 40W is guaranteed from 0.2 to
3.5 Ohms. Resistances of 0.05 to 5 Ohms are possible but with a reduced power.
1. Temperature controlled vaping
In this mode the mod will regulate the temperature of the coil to the pre-set value, except
the power setting is too low to achieve the temperature. So please note to adjust the
power setting to a value high enough, if you choose temperature controlled vaping.
Otherwise the temperature regulation changes to a temperature limitation mode.
When Hctrl is set to 1, the menu directly jumps to the selection of the wire type. Here the
user can select between dicodes-wire (NiFe30), Nickel 200, Titan, Tungsten (Wolfram),
Stainless Stell (Inox) and “Other”. With “Other” selected, the temperature coefficient defined
in the Extended Functions Menu under item “Tmp. Cof” is used. The value of the
selected coefficient is displayed behind “Wire”. For commonly used wires, the predefined
coefficents are: NiFe30=320, Nickel200=620,Titanium=350, Tungsten=440 and Stainless
Steel=105. Note that there are different alloys for Titanium and Stainless Steel on the
market, so the predefined values can deviate from the actual wire-value you use.
…
Summary of Contents for Dani Extreme V2+
Page 1: ...manual Dani Extreme V2 ...
