06 Extended Functions Menu (Page 1: Overview)
Increase wire
temperature
coefficient
(*1)
Decrease wire
temperature
coefficient (*1)
Set Power Limit
(40Wmax.)
Select heater
protection mode
(1..10)
Select power
boost mode
(1..10)
Set the minimum bat
discharge level
(2.5..3V)
Set display luminosity
(1 low to 5 high
brightness)
Select auto power
off time (1-2-5-10-15-
20-30-60 minutes)
Select number of clicks
to switch on mod (0..5).
0=> immediate vape
Select number of clicks
to get into the menu
(1..5).
Speed for button
usage (1 fast..5 slow).
(*2 )
Select wattage steps
1W/0.5W (<20W) and
2W/1W (20-40W)
Selects temperature
unit either °Celsius or
°Fahrenheit.
Select display
orientation between
Left and Right (handed)
Select Expert mode to
enable power boost,
heater protection and
bypass mode.
Switch back all settings
to factory defaults
(refer to manual).
Counts the number of
puffs since last counter
reset.
Displays pure vaping
time in H:MM:SS since
last counter reset
Energy taken from
battery during vaping
since last counter reset
Displays battery
capcitance since last
counter reset (can
show battery quality)
Reset the counters
above.
Total lifetime puffs
of mod.
Not resettable.
Total lifetime vaping
time of mod in
HHHH:MM
Not resettable.
(*2 ) Setting 1 (fastest) as 2 but without animation (visual shift effect), setting 5 (slowest) as 4, but without
fast auto-repeat.
(*1 ) The temperature coefficient selects the type of wire material, range 100 to 650: When TC-mode is selected
(Main menu HCtrl=1), the user must select the wire type to be NiFe30 (dicodes wire), Ni200, Titanium, Tungsten
(Wolfram), Stainless Steel (Inox) or “Other”. The value for “Other” is adjusted here. The values of the predefined
wire-types are 320=dicodes-wire, 620=Nickel, about 105=Stainless Steel, 350=Titanium (varying literature values,
danger: fire harzard), 440=Tungsten (Wolfram). Value to select = Literature-value*10E5 K.
Example: Ni 6.2E-3*1/K * 10E5*K => 620
Paramter display during
vape on/off (*3)
(*3 ) When temperature controlled vaping mode is selected and with diplay mode=1, the current values of
“Power”, “Temperature” and “Wire-Resistance” can be observed during the vape. In standard mode, the battery
symbol, power and resistance is displayed. In Bypass mode the calculated power is displayed.
With display mode =0 these parameters are displayed after the vape with the latest values.
Summary of Contents for Dani Extreme V2+
Page 1: ...manual Dani Extreme V2 ...
