E100301X rev5
21/02/14
- Defects occurred in the power supply;
- Not authorized modification made on the
machine;
- The machine is used by not authorized
personnel.
4. UNPACKING
The machine must be controlled at the delivery
moment, any external or inside damage dues to
the transport, must be reported immediately to the
forwarder.
ATTENTION!
Moving the machine, remember that the dryer
centre of gravity is located in the last third of the
machine height.
Machine must be completely unpacked next to the
installation place. Straps must be cut and the
covering packing material must be taken off.
Packing materials must be wasted following the
rules in subject of environment protection.
Using a key, take away the nuts on the machine
base which are fixing the dryer to the pallet
(frontal and back).
ATTENTION!
Check the machine net and gross weight on the
technical data sheet sent with the machine: it
must comply with the available lifting means.
ATTENTION!
Pallet cannot be used as normal dryer support!
The machine must always be installed without the
pallet and positioned as described in the relative
paragraph.
ATTENTION!
The machine can be moved only when it is fixed
on its pallet: the machine handling must be done
only by trained and competent personnel.
5. MACHINE IDENTIFICATION
The dryer is identified by the sticker reporting the
machine serial number, model, power and
technical characteristics.
Be sure that the electrical, hydraulic, steam, gas,
compressed air connections are complying with
the sticker data.
Spare parts and / or services require the correct
model identification.
If the serial number sticker is tampered, missing,
removed or damaged in a way that does not allow
a correct machine identification, the dryer
installation and service can be difficult and the
warranty automatically expires.
6. INSTALLATION AND POSITIONING
Installation must be trained by qualified personnel.
Machine must be positioned on a plane surface
horizontally and in a stable way using the
adjustable feet at the dryer base. Feet can be
adjusted from outside, screwing and unscrewing
them until the dryer is correctly positioned.
In models where it is provided, the feet can be
adjusted from inside using a 5mm hexagonal key
after the filter door and the back panel have been
opened
Always check if the floor can bear the machine
weight written in the technical data sheet The
machine load can be considered totally static. To
calculate the dryer static load, the weight of the
