E100301X rev5
21/02/14
ATTENTION!
In order to be efficient, the safety valve must
be of a adequate size to provide to the
maximum steam system rate.
5) Vacuum breaker valves
6) Filter
7) Inverted bucket steam trap
8) Flow indicator
OUT) Machine steam heater outlet
ATTENTION!
Drying productivity depend on the steam
heater efficiency.
Dryer can work with the steam pressure range
referred in the technical data sheet, anyway
lower is the pressure, more poor are the
machine performance. In order to avoid too
much longer drying time, the pressure should
be at least 5bar.
17. COMPRESSED AIR CONNECTION
Connection to a compressed air system is
necessary for some dryer models: check the
equipment data sheet.
System must be performed by qualified personnel
in compliance with national and local rules in
force.
Connection between system and dryer must be
tight tested; it is suggested to use a leak finder
spray. In case of air leaks, stop them.
18. MACHINE DESCRIPTION
The dryer is characterized from some elements
which must be known before to use the machine.
The point nr 1 identifies to the heater door. In
case of service, the door can be opened using the
plastic key supplied with the machine, inside the
documents envelope.
Only competent and specialized personnel is
allowed to access to the electric board.
The point nr 2 identifies the control board area,
which can be electronic (microprocessor) or
electro-mechanic (double timer).
The point nr 3 identifies the door of the dryer.
The point nr 4 identifies the filter door. It must be
open each time the filter needs to be cleaned. The
access to the filter must be allowed only to
specialized an competent personnel.
The point nr 5 identifies the electric connection
box and a part of the electric system.
The point nr 6 identifies the humid air exhaust
(always) and the burn gas exhaust (in case of gas
heated machines).
ATTENTION!
Air intakes on the machine back must be
always free. The air passage must not be
limited in any way.
19. PREPARE THE LINEN
Dryer must be loaded on the base of the data
written on the serial number plate: the dryer must
not be loaded with a weight above the nominal
load written on the serial number plate.
Before to decide the most adequate program,
divided the linen into groups, which should be
homogeneous for kind of fabrics or fibres, in order
to reach a uniform drying inside the drum.
Only spin linen must be loaded into the dryer.
Always be sure that batcher or other object are
not among the linen.
Be sure that, during the washing, softener (or
similar products) were used in compliance with
the linen manufacturer instructions.
Before to dry the linen, be sure that the garments
instructions allow the tumbling. The linen must be
wet washed.
Below some international symbol explication:
Normal temperature drying
Low temperature drying
Do not tumble.
ATTENTION!
Do not use the machine if chemical products
were used to wash.
Do not use the machine in case of self-igniting
fabrics.
Linen to be dried must not have been in
contact with dangerous substances such as
