Planetary mixer TEKNO 40 - 60
22
SECTION B POINT 2
PREPARING THE ROOM - INSTALLING THE MACHINE
PREPARING THE ROOM
The room where the machine is installed and any existing equipment already installed in the room must
comply with the directives, regulations, standards and technical specifications etc. in force in the user’s
country (E.U. or EFTA).
INSTALLING THE MACHINE
The machine is attached to the bottom of the packaging by means of three screws located inside the
supporting foot. To access them, unscrew the spherical caps and remove the clamping screws using a 10
mm socket spanner. Refit the caps.
The purchaser/user or his representative must check the condition of the machine upon unpacking,
immediately notifying the manufacturer of any damage or defects encountered.
For installation of the machine, the specifications on the identification plate illustrated in Section A point 1
and the overall dimensions given in Section A point 2 should be taken into account.
You should also remember to adjust the feet to ensure that the machine is level as explained in Section A
point 6.
An area of approximately 50 cm must be left free all around the machine for use and maintenance. The
normal working position is not established beforehand.
The machine is designed to operate in the normal temperature and humidity conditions found in EU and
EFTA countries.
The machine must not under any circumstances be used in places where there is the danger of
explosion or fire due to the presence or generation of dust, gas or explosive or flammable mixtures.
For connection of the machine to the electrical power source, see points 4 and 5 of Section B.
If the machine is installed by
the manufacturer’s personnel, the latter will demonstrate, in the presence of the
purchaser/user or his representative, connection to the electrical power source, start-up, adjustment, use
etc., and point out the main instructions contained in this manual.
