Diamond Products CC2525H, Operator'S Manual

Page: 19 / 40

CC2525H OPERATOR’S MANUAL
Transmission Engagement Lever
Engaging the Transmission
1. Place the speed control lever at Neutral.
2. Start the engine.
3. Push the transmission engagement lever
down to engage.
Disengaging the Transmission
1. Place the speed control lever at Neutral.
2. Pull the transmission engagement lever up
to disengage.
Maneuvering the Saw Manually
1. Extend the handlebars to a desired location
for best leverage.
2. Raise the blade as high as possible to
prevent it from striking the ground.
3. Place the speed control lever into the
neutral position.
4. Lift the rear wheels to just above the
pavement and manually maneuver the as
required.
Maneuvering the Saw with Power
NOTE: When maneuvering the saw using
power, the engine should be running at one
half throttle or greater so the transmission can
operate efficiently. For maximum speed in
forward or reverse, the engine must be running
at full throttle.
1. Extend the handlebars to a desired location
for best leverage.
2. Raise the blade as high as possible to
prevent it from striking the ground.
3. Place the speed control lever into the
neutral position.
4. Engage the transmission drive.
5. Move the speed control lever in either the
forward or reverse direction to maneuver
the saw as required.
Fuel System
WARNING
Always use caution when refueling.
DO NOT operate the saw with a fuel leak.
DO NOT fuel the saw with the
engine running.
DO NOT smoke or expose fuel to
open flames when filling the fuel
tank or working with fuel.
CAUTION
Clean up any spilled fuel prior to starting the
engine.
Fuel may seep out from the fuel cap vent
(applicable models) when raising the
saw if the fuel tank is overfilled.
Adding Fuel
1. Lower the saw to level the frame.
2. Turn off the engine and let the saw cool
down.
3. Remove the fuel tank cap.
4. Fill the fuel tank with unleaded, 86 octane
or higher, fuel only. DO NOT overfill the
tank for expansion purposes. Refer to the
engine manual for additional information.
5. Replace the fuel tank cap and secure.
Fuel Shutoff Valve
A ball valve is provided below the fuel tank.
During operation the shutoff valve must be
open to provide fuel to the engine. When not in
operation it is best to have the shutoff valve
closed.
Water Supply
The water supply cools the blade and
minimizes dust when cutting. There are two
blade guard hose connections on the saw, one
on the right side and one on the left. The
connection on the right side has a water cutout
valve to start and stop the flow of water to the
blade. The left side has a hose connection for
attaching the water source hose.
Note: Always test the water supply for
adequate pressure and flow prior to cutting.
19