CC2525H OPERATOR’S MANUAL
Operating
General Operating Precautions
•
Prior to operating the machine, read the
operator’s manual thoroughly and ensure
that you understand the safe and proper
operation of the machine.
•
Use approved personal protective
equipment at all times while operating the
machine.
•
Ensure that there is firefighting equipment
and a first aid kit nearby while operating the
machine.
•
Ensure the cutting area is free of
obstructions, people, and or animals prior
to operating the machine.
•
Always operate the machine from the
operator’s position at the rear of the
machine between the handlebars.
•
Do not stand in front or behind the blade
path while the engine is running.
Emergency Stop
If an emergency condition should arise, the
machine is equipped with an emergency stop
button located on the top of the control panel.
The emergency stop places the machine into
safe mode allowing the operator to address the
emergency condition.
NOTE: Only use the emergency stop in an
emergency condition. Do not use it to stop the
machine during normal operations.
Emergency Stop Button
Activating the Emergency Stop
To activate the emergency stop, press down
on the emergency stop button. The engine will
shut off placing the saw in a safe condition.
Deactivating the Emergency Stop
Prior to deactivating the emergency stop,
ensure that the machine is back into a safe
operating condition. Then turn the emergency
stop button clockwise until it springs back into
position. The machine can now be restarted.
Handlebars
The handlebars help to guide and maneuver
the saw.
Adjusting the Handlebars
1. Loosen both of the handlebar lock knobs.
2. Hold the handlebar grip and place the first
handlebar into the handlebar opening
below the handle lock knob. The handlebar
can fit through two different angled
pathways inside the handlebar opening.
Select the handlebar angle that works best
for the current task.
3. Move the handlebar forward or backward to
adjust the length.
NOTE: Maintain a minimum of 6” of handlebar
into the handlebar tube at all times.
4. Tighten the handlebar lock knob to secure
the handlebar.
Handlebar and Lock Knob
5. Repeat steps 2 – 4 to secure the second
handlebar. Adjust the handlebar orientation
and length prior to operating the saw.
16
Summary of Contents for CC2525H
