Di-LOG CombiVolt 5, Instruction Manual

Page: 18 / 38

DL6799 OPERATING MANUAL
2. Measuring of DC Current (DCI)
(1) Set the rotary dial to ; Press the “SELECT”
key to switch the function to DC current;
(2) A short press of the ZERO button before performing
a DCI measurement will allow the instrument to zero
any displayed values caused by terrestrial mag-
netism . The instrument will display ZERO in the
secondary display to indicate you have entered zero
mode.
(3) Place the conductor at the bottom of the open
jaw “U”. The instrument will automatically select the
correct range. If the current direction is the same as that
of clamp head, it will display the positive value of DC
current on the display screen, otherwise, it will display
the negative current value:
Warning:
The largest measured current shall not be greater
than DC 200A during the measurement of DC
current.
15
Di-LOG
...measurably better