2.1-Transmitter enable / disable
Sequence: E + 1 +1
It is a cyclic operation key, if the transmitter is disabled, it activates it and vice versa.
If the transmitter is disabled, the display shows:
The
"TX"
LED on the
MEASURING AND CONTROL PANEL
will light up.
At the end of the operation the panel returns to
P2
.
If the transmitter is enabled, the display shows for 2 seconds:
At the end of the operation the panel returns to
P2
.
CAUTION: The equipment retains in non volatile memory the last state in which the function
was found to activate / deactivate the transmitter when switching it off intentionally or
accidentally, pej. before a power cut. In this way, if the transmitter was activated, when it is
turned on again or the power is restored, it will start up in transmission. Special care must be
taken when turning on the equipment that is connected to the load, if the status of the
activation / deactivation of the transmitter was not known before turning it off, otherwise the
destruction of the power stage of the transmitter may occur. RF.
SECTION 9/3
TRANS: ENA WAIT
TRANS:DIS
Summary of Contents for STAL1000
Page 10: ...SECTION 6...
