DFI P5XV3, User Manual, Page: 17 / 78

2
Hardware Installation
17
1. Pull the “tabs” which are at the ends of the socket to the side.
2. Position the DIMM above the socket with the “notches” in the
module aligned with the “keys” on the socket.
3. Seat the module vertically into the socket. Make sure it is
completely seated. The tabs will hold the DIMM in place.
Installing the DIM Module
A DIM module simply snaps into a socket on the system board.
Pin 1 of the DIM module must correspond with Pin 1 of the
socket.
2.2.1.2 SIMM
The two 72-pin SIMM (Single
In-line Memory Module) sockets
use EDO or FPM x32 DRAM.
Refer to the table on the next
page for the bank locations and
modules needed for the
corresponding memory sizes.
Pin 1
Notch
Key
Tab
Tab