27
2
Hardware Installation
2.6.10 J13 (LEDs and Switches)
SP-LED - ATX 5VSB Standby LED
This LED will light when the 5VSB power is active.
SP-SW - ATX Power Switch
Depending on the setting in the BIOS setup, this switch is a dual
function power button that will allow your system to enter the Soft-
Off or Suspend mode. Refer to Soft-Off By PWRBTN in the Power
Management Setup (Chapter 3) of the Award BIOS.
HD-LED - Primary/Secondary IDE LED
This LED will light when the hard drive is being accessed.
G-LED - Green LED
This LED will light when the system is in the Suspend mode.
G-SW - Green Switch
This switch will allow your system to enter the Suspend mode. To
wake up the system, PM Events in the Power Management Setup
(Chapter 3) must be enabled so that access to the specified IRQ
will allow the system to wake up completely from the Suspend
mode.
H-RST - Reset Switch
This switch allows you to reboot without having to power off the
system thus prolonging the life of the power supply or system.
SPEAKER - Speaker Connector
This connects to the speaker installed in the system chassis.
