22
2
Hardware Installation
2.6.2 PS/2 Mouse Port
The PS/2 mouse port is a 6-pin connector on the system board.
Attach the 6-pin mouse port cable, which is mounted on a card-
edge bracket, to connector J1. Make sure the red wire on the PS/2
mouse connector is aligned with pin 1 of connector J1. Mount the
card-edge bracket to the system chassis.
Pin
1
2
3
4
5
6
Function
Mouse Data
Reserved
Ground
+5V
Mouse Clock
Reserved
2.6.3 Parallel Port
The system board has a standard printer port for interfacing your
PC to a parallel printer. It supports SPP, ECP and EPP modes. You
can set the ports mode in the Integrated Peripherals setup of the
Award BIOS.
Connecting the Parallel Printer Port
Attach the DB-25 printer port
cable to connector J9 on the
system board. Make sure the
colored stripe on the ribbon
cable aligns with pin 1 of J9. Use
a small nutdriver to mount the
cable into a DB-25 cutout in the
system chassis. If your printer
port cable is attached to a card-
edge bracket, connect the cable
to connector J9 on the system
board and mount the card-edge
bracket to the system chassis.
