56
2
Hardware Installation
BIOS Setting
Configure the onboard audio in the Integrated Peripherals submenu
of the BIOS. Refer to chapter 3 for more information.
Driver Installation
Install “Audio Drivers”. Refer to chapter 4 for more information.
Front Audio
The front audio connector (J4) on the Karajan audio module allows
you to connect to the line-out and mic-in jacks that are at the front
panel of your system. Using this connector will disable the rear au-
dio’s line-out and mic-in functions.
Audio
codec
1
1
Line-in
Front R/L
Mic-in
Center/Subwoofer
Rear R/L
Side R/L
X
1
2
1 0
9
Mic_Left
GND
Mic_Right
Vcc
Line out_Right
N.
C
.
N.
C
.
Line out_Left
Line out_Left_Front
Remove the jumper caps from pins 5-6 and pins 9-10 of J4 prior to
connecting the front audio cable connector. Make sure pin 1 of the
cable connector is aligned with pin 1 of J4. If you are not using this
connector, make sure to replace the jumper caps back to their
original pin locations.
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
Line out_Right_Front
