DFI G586OPC/E, User Manual

Page: 98 / 102

PCI/ISA System Board
90
DISPLAY SWITCH IS SET INCORRECTLY
The display switch on the motherboard can be set to
either monochrome or color. This indicates the switch is
set to a different setting than indicated in Setup. Deter-
mine which setting is correct, and then either turn off
the system and change the jumper, or enter Setup and
change the VIDEO selection.
DISPLAY TYPE HAS CHANGED SINCE LAST BOOT
Since last powering off the system, the display adapter
has been changed. You must configure the system for
the new display type.
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
Hard drive cannot be initialized. Be sure the adapter is
installed correctly and all cables are correctly and firmly
attached. Also, be sure the correct hard drive type is
selected in Setup (refer to page 22).
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize controller. Make sure the card is
correctly and firmly installed in the bus. Be sure the
correct hard drive type is selected in Setup. Also, check
to see if any jumper needs to be set correctly on the
hard drive.
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR
PRESENT
Cannot find or initialize the floppy drive controller.
Make sure the controller is installed correctly and
firmly. If no floppy drive is installed, be sure the Dis-
kette Drive selection in Setup is set to NONE.