65
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT
The system cannot find or initialize the floppy drive controller. Make
sure the controller is installed correctly and firmly. If no floppy drive is
installed, be sure the Diskette Drive selection in Setup is set to NONE.
KEYBOARD ERROR OR NO KEYBOARD PRESENT
Cannot initialize the keyboard. Make sure the keyboard is attached cor-
rectly and no keys are being pressed during the boot.
If you are purposely configuring the system without a keyboard, set the
error halt condition in Setup to HALT ON ALL, BUT KEYBOARD. This
will cause the BIOS to ignore the missing keyboard and continue the
boot.
MEMORY ADDRESS ERROR AT...
Indicates a memory address error at a specific location. You can use
this location along with the memory map for your system to find and
replace the bad memory chips.
MEMORY SIZE HAS CHANGED SINCE LAST BOOT
Memory has been added or removed since the last boot. Enter Setup
and enter the new memory size in the memory fields.
MEMORY VERIFY ERROR AT...
Indicates an error verifying a value already written to memory. Use the
location along with your system’s memory map to locate the bad chip.
OFFENDING ADDRESS NOT FOUND
This message is used in conjunction with the I/O CHANNEL CHECK
and RAM PARITY ERROR messages when the segment that has
caused the problem cannot be isolated.
OFFENDING SEGMENT
This message is used in conjunction with the I/O CHANNEL CHECK
and RAM PARITY ERROR messages when the segment that has
caused the problem has been isolated.
