19
Installing the Cache Module
Locate the 160-pin cache module slot on the system board (SSM1).
Refer to page 14 for the location of SSM1. Position the cache module
above the slot. Make sure pin 1 of the cache module is aligned with pin
1 of the slot. Carefully slide the module into the slot. Press firmly on the
top of it to seat it properly.
Note:
With the cache module installed in the cache module slot, the compo-
nents on the solder side of the add-in card in PCI Slot 3 must not
protrude more than 5mm. The components of the component side of
the add-in card in PCI Slot 2 also must not protrude more than 5mm.
CPU Installation
The G586IPV allows for easy installation of CPUs. Make sure all jumpers
are set correctly before applying power or you may damage the CPU or
system board. Please see the jumper settings on the following pages. Use
the needle-nosed plier to move the jumpers if necessary.
Jumper Settings for CPUs
