69
33
BIOS Setup
PnP/PCI Configurations
This section describes configuring the PCI bus system. It covers
some very technical items and it is strongly recommended that only
experienced users should make any changes to the default settings.
Reset Configuration Data
Enabled
The BIOS will reset the Extended System Configuration
Data (ESCD) once automatically. It will then recreate a
new set of configuration data.
Disabled
The BIOS will not reset the configuration data.
The settings on the screen are for reference only. Your version may not be
identical to this one.
X
X
CMOS Setup Utility - Copyright (C) 1984-2000 Award Software
PnP/PCI Configurations
Reset Configuration Data
Resources Controlled By
IRQ Resources
DMA Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
Disabled
Auto(ESCD)
Press Enter
Press Enter
Disabled
Enabled
Enabled
Item Help
Menu Level
Default is Disabled.
Select Enabled to
reset Extended System
Configuration Data
(ESCD) when you exit
Setup if you have
installed a new add-on
and the system
reconfiguration has
caused such a serious
conflict that the OS
cannot boot.
↑↓→←
Move
F6:Fail-Safe Defaults
F7:Optimized Defaults
F1:General Help
Enter:Select
F5:Previous Values
+/-/PU/PD:Value
F10:Save
ESC:Exit
IRQs Activity Monitoring
Move the cursor to this field and press <Enter>.
The “Primary
INTR” field,
when set to On, will allow the system to respond
and wake up to an IRQ activity that has been detected. When
any of the “IRQ3” to “IRQ15” fields is enabled, access to the
specified IRQ will cause the system to wake up completely from
the power management mode. When disabled, the system will
not wake up from the power management mode despite access
to the specified IRQ.
