41
2
Hardware Installation
Wake-On-Ring Connector
The Wake-On-Ring connector is used to connect to an internal
modem add-in card that has the same connector. It will allow the
system that is in the Suspend mode or Soft Power Off mode to
wake-up/power-on to respond to calls coming through the internal
modem card.
To use this function, connect one end of the cable (that came with
the card) to the card’s wake-on-ring connector and the other end to
location J14 on the system board.
If you are using an external modem, the ring-on function will come
through the serial port where the external modem is connected.
Important:
If you are using a modem add-in card, the 5VSB power source
of your power supply must support
≥
720mA.
BIOS Setting
Enable the “Wake Up On LAN/Ring” field in the Power Management
Setup submenu (“Wake Up Events” section) of the BIOS.
X
2
1
Ground
RI#
