www.dfi .com
Chapter 2 Hardware Installation
18
Chapter 2
Installing BT700 onto a Carrier Board
1. The photo below shows the locations of the mounting holes and the bolts already fixed in
place.
2. Grasping BT700 by its edges, insert it into the carrier board, and you will hear a distinctive
”click” indicating BT700 is correctly locked into position.
Mounting hole
BT700
Carrier board
Standoff Bolts
3. Press down BT700 and put on the heat sink on top of BT700 with its mounting holes and
bolts aligned on the carrier board. Use the mounting screws to fix BT700 and heat sink in
place.
Short screws
Important:
The carrier board used in this section is for reference purpose only and may not
resemble your carrier board. These illustrations are mainly to guide you on how to
install BT700 onto the carrier board of your choice.
