DFRobot
版权所有
Copyright © DFRobot. All rights reserved.CC BY-NC 3.0 CN
P a g e
|
10
1
） 在
Arduino IDE
中打开
WeatherStation
中
example
样例程序
Open the example program under WeatherStation, which is within the Arduino IDE
2
） 将样例程序下载到主控板
Download the example program to the main control panel
3
） 将
4Drawing
控制板上的开关拨到
“RUN”
状态
Turn the switch on the 4Drawing control panel to “RUN” as it is shown below
4
制作
Assembling
1.1 前板安装
Assemble the Front Plate
将触摸模块和
LCD
如图方式用固定在前面板上，并将配套线缆接入相应的模块接口。
安装
LCD
时，在图中红色圆圈的地方需要
3-4
片垫片，用以保持
LCD
安装后的平整。
Fix the Touch Panel & LCD Module on the front plate just as it is shown in the photo below and
slide cables into correspondent connectors of the modules. When assembling the LCD Module,
place three or four spacers on the area within the red circle as it’s shown in the photo below to
keep the front plate even.
