Installation/User
Manual
10
Installation Procedures
WARNING:
Prior to installing any of the microinverters, verify
that the utility voltage at the point of common connection matches
the voltage rating on microinverter label.
WARNING:
Do not place the inverters (including DC and AC connectors)
where exposed to the sun, rain or snow, even gap between modules.
Allow a minimum of 3/4’’(1.5cm.) between the roof and the bottom of the
Microinverter to allow proper air flow.
Stpe
3
-
Connect
the
microinverters
in parallel
a. Check the Microinverter
technical data page(p.18)
for the maximum
allowable number of Microinverters on each AC branch circuit.
b. Plug the male
AC connector of the Microinverter
into the female connector to get it connected.
AC connector interface as follows.
WARNING:
Do NOT exceed maximum number of Microinverters
in an AC branch circuit, as displayed on the page 7 of this manual.
600w
connect in parallel
1300w connect in parallel
