26
EN
8. TROUBLE SHOOTING
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore, check the product using this section. In most cases the problem can be solved quickly.
WARNING!
Only perform the steps described in these instructions!
All further inspection, maintenance and repair work must be performed by an
authorised service centre or a similarly qualified specialist if you cannot solve the
problem yourself!
Problem
Possible cause
Solution
1. Product does
not start
1.1. Not connected to the
power supply
1.2. Power cord or plug is
defective
1.3. Another electrical defect
in the product
1.1. Connect to the power
supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source (e. g.
generator) has too low
voltage
2.3. Air vents are blocked
2.1. Use a proper extension
cord
2.2. Connect to another
power source
2.3. Clean the air vents
3. Unsatisfactory
result
3.1. Sanding belt is worn
3.2. Sanding belt not
suitable for work piece
material
3.1. Replace with new one
3.2. Use proper sanding belt
Summary of Contents for S1T-YH-13B
Page 30: ...29 EN ...