Dexter Power A7188-DP-1, Legal And Safety Instructions

Page: 27 / 30

EN
6. MAINTENANCE
DANGER! Risk of injury due to electric shock.
Warning! Always remove the plug from the socket before servicing,
cleaning or storage.
• Your power tool requires no additional lubrication or maintenance. Always store your power tool
in a dry place.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualifi¬ed persons in order to avoid a hazard.
• If a fault cannot be rectifi¬ed, return the polisher to an authorized dealer for repair.
Cleaning
• Keep the safety devices, ventilation slots and Motor housing as free of dirt and dust as possible.
Clean the unit by rubbing it with a clean cloth or blow it clean using low-pressure compressed air.
• We recommend that you always clean the unit immediately after using it.
• Clean the unit regularly by rubbing it with a damp cloth and a little soft soap. Do not use cleaners
or solvents; these will attack the plastic parts in the unit. You must also ensure that water cannot
get into the inside of the unit.
25
7. TROUBLE SHOOTING
Problems Probable causes Corrective actions
The polisher fails to
start up.
No Power.
Foreign substances have got
inside the motor.
Lack of or contaminated
lubrication grease.
Check Voltage and Ensure
polisher switch is switched on.
Have the foreign substances
removed.
Have lubricating grease
applied or replaced.
Motor gets hot.
DANGER! Risk of injury due to electric shock.
Warning! Before any trouble shooting, switch off the pump and
remove the plug from the socket.
Carbon brushes
• If excessive sparking occurs you must have the carbon brushes checked by a quailed electrician.
• Attention! Only a quailed electrician is allowed to change the brushes.